In the U. S. , the correct amperage rating is 240 volts. You can find out the circuit’s amp rating by checking the fuse or breaker box in your home. It is usually labeled. Compare the label to the power requirement listed in the cooker’s owner’s manual. If you’re not sure how your home’s electrical wiring is set up, ask an electrician to inspect it and make sure it is safe to use.
The switch connects the cooker’s control unit to the electrical supply in your home. If you have an old cooker, then your home probably has the correct switch needed for the new one. Deactivate both switches each time you need to access the cooker’s wiring. It will help keep you safe.
You usually don’t have much choice when placing a new unit. It has to be close to the control unit and switch. If you wish to move it, ask an electrician about adjusting your home’s wiring. If you’re placing a new cooker, make sure it isn’t underneath wallpaper or other flammable objects.
If you don’t see the fuse or breaker panel, check recessed areas like hallway closets. It may also be outdoors, near the electrical meter, in some cases. After deactivating the switch, consider locking the fuse or breaker panel so that no one can accidentally reactivate the power while you’re working. After deactivating the switch, check the manufacturer’s recommendations for installation. Follow an electrical code book and rules for safe when wiring and installation.
If the box doesn’t have any screws on it, use a flathead screwdriver to gently pry the cover off. You can lift it by sliding the screwdriver underneath its bottom edge.
You don’t need to remove the screws. Loosen them enough to plug the wires into the terminals. If the wires don’t fit, you can always go back and loosen the screws a little more. Check the cooktop’s user manual for more information about which terminals to use for the electrical wires. Your unit may also have a sticker on the back indicating how the terminals work.
Note that new cookers come with the required power cable. If you need a new one, make sure it is the right size. Try using a 2. 5 mm (0. 098 in) heat-resistant cable, for instance. The wiring color scheme may be different depending on where you live. Look up your country’s electrical code to figure out what the wire colors represent. The ground wire often has no casing, but leaving it exposed is dangerous. To protect it from shorting out or shocking you, purchase an electrical wire sleeve. The sleeve is a piece of insulation, usually colored green and yellow, that fits around the wire to insulate it.
Check for any loose wires sticking out of the case. If you see any, open the case up and pack them neatly into the outlet box. If the wires are too long, you can trim off the ends using pliers. Strip off the insulation using a wire stripping tool if you need to expose more of the wire.
If the switch is on, then the control unit may still shock you. Don’t attempt to wire it until you’re sure it is off and have finished testing it.
Use the isolator switch, along with your home’s circuit breaker or fuse box, to shut off the electricity. Working on a live outlet is very dangerous, so always double-check it with a multimeter! Test the other terminals in the outlet by moving the probes to them. Make sure the multimeter doesn’t react at all.
The screws usually do not need to be removed in order to fit the wires in place.
For example, your unit may have a brown neutral wire on the left, a green and yellow ground wire in the middle, and a blue power wire on the right. It depends on the wire color scheme used in your country.
If the wires are frayed or loose in the box, the cooker won’t work properly. Bad wiring could potentially damage your cooker or lead to other problems, so take your time with them before reactivating the power.
Even if you wired the cooker correctly, not having a certificate could become a problem. The certificate proves that your home is safe and meets government regulations. Without it, you may not be eligible for property insurance and have a hard time selling your home in the future. Getting a second opinion is always useful when it comes to electrical work. Electrical work is delicate and mistakes can have serious consequences.
